How To Grow Grapes Plant At Home

By | December 25, 2016

Growing Grapes

We have plenty of wild concord grapes on our property. However, the insurance company doesn’t approve of our harvesting methods so it’s probably best to plant some cultivated grapes. When I cleared the land for the greenhouse, it left plenty of area to plant various fruit producing plants which don’t need the greenhouse to thrive. Plus why waste the space just growing grass? Taking a look at my 3rd grade drawing skills, I’m going to set three 4x4x10′ treated posts 34 feet into the ground and space them 24′ apart. This will allow for 8 plants in the space. Then I’ll string 12 gauge galvanized wire starting with the first wire 4246quot; from.

The ground, then space the other two 12quot; apart. The plants can be spaced 6′ apart and over time the vines can be trained along the 3 wires. I had planned to set the posts first in the event that I hit any large rocks while digging, however I blew a seal on the backhoe and had to find some parts for it. So I took my chances and put the plants in first. The row should go in a straight line and a 100′ tape measure works well for marking out the locations of each post and plant. Jamming a piece of survey’s tape at each mark does the trick. We’re going oldschool and using a pickaxe and shovel and digging a hole about 1 foot deep. Luckily there weren’t any large rocks in the way just.

A few roots and small stones that the pickaxe was able to pluck out. Later, looking at the post holes, you’ll see why I didn’t dig them by hand. Planting the vines is fairly easy. I got these seedless concord grapes from Gurney’s for half price. I just remove the fiber that’s used for keeping the roots damp, spread out the roots a bit, and set it in the hole so that all the roots that emerge from the vine will be just below the finished level of the soil. All the dirt that came out of the hole was hardpan so I filled it with nice organic soil, then compacted it down, and gave it a really good watering. It also important to cover the area with mulch to help maintain.

The moisture in the soil until the roots can get established. These will get watered every day for a couple of weeks. The actual work of planting the vines is quick. It’s the preparation of digging out the rocks that takes all the time. A 30 cent Oring and a day to dismantle and reassemble the valve assembly and the backhoe is running again. I can now install the posts for the wire arbor. It may not be the fastest backhoe, but it beats digging through the rock with a pick and shovel. The holes are dug to about 4 feet which will provide a deep enough anchor to prevent the posts from leaning.

From the future weight of the vines. Some of the rocks that I pulled out where bigger than the hole. If I had to dig these by hand, I probably would have only dug down a couple of feet, and then would have to anchor the posts with concrete and guywires. It seems like a really big hole for a post, but without an auger with rock drilling bit, it’s probably the easiest way to set a post. A little cleanup at the bottom of the hole and it’s ready. I’m using 4×4 treated lumber rated for direct burial. I’m not a fan of using treated lumber, but in order for it to last a long time, it’s a necessary evil. I like to add two temporary cleats to the post to help support it while I’m set it plumb.

And backfill the hole. I also like to drop a few rocks around the base to hold it in place when I start to fill it in. I’ll fill the hole several inches at a time and compact it between each layer, then clean up the area with some more woodchip mulch. The first wire starts roughly 4246 inches from the ground and the second and 3 wires are spaced 12 inches apart. It will be the perfect snacking height for the deer. At each marking I’ll drill a 38quot; hole through the post and then put in a 516quot; eyebolt. The back side has a large fender washer and nut. Having a large washer will help to keep the nut from pulling into the post under the weight of the vines. It’s fairly important to make.

Sure the eye bolt is an inch or more too long so you can tighten the nut if there’s a little slack in the wire. I’m using 12 gauge galvanized wire and I like to roll it out first and cut it to its rough length. Then I insert it through the bolt and bend it back on to itself, anchoring it with a wire clamp. The wire is stiff enough where you probably could just twist it over itself, but I just prefer the wire clamp. I drilled holes through the center post, but most people usually just staple the wire to the side of the post. I’m a bit obsessive compulsive and can’t handle having a bunch.

Home Vineyard Growing Wine Grapes at Home

Hello and welcome to my home vineyard Let’s get a lay of the land. As you can see this is just a simple side yard it’s got about 55 feet of space long twentysix feet of space wide we elected to go with twenty twofoot long rows northsouth facing uh. the rows are spaced about five feet apart to give us ample space for the vines to grow.

And for us to manage and walk through we are planting about four plants per row to give it plenty of space to spread out and grow for the rows, we used uh. just simple fence posts these are eightfoot fence post sunk about three feet deep we tried to go about two feet deep but it wasn’t uh. it just simply wasn’t stable enough so we went that extra foot for stability.

The wire is fourteen gauge wire uh. we elected to go with the vertical trellising partly because it was easier and partly because uh. the north south facing rows, it allow it to get sun at all hours of the day uh. we have a drip irrigation lines ran along the bottom we will be using half gallon per hour drips two per plant that allows us to adjust the water.

Water flow and manage the irrigation a little easier than if we used a heavier flow we’ll actually be planting syrah grapes because we tend to be in a warmer, drier climate during the summer doing something like pinot noir would require greater cooler temperatures. that sort of thing that’s our vineyard. We’ll be planting the grapes next week and we’ll come back then.

Leave a Reply